As it turns out, you can put a price on peace of mind.
Amp AV handles security camera installation in Mesa and across the East Valley, our own back yard. Amp AV’s shop is on West Birchwood Avenue in Mesa, so this is the city we work in most and the one we can reach fastest.
Security Camera Installation in Mesa, AZ
As it turns out, you can put a price on peace of mind.
Amp AV handles security camera installation in Mesa and across the East Valley, our own back yard. Amp AV’s shop is on West Birchwood Avenue in Mesa, so this is the city we work in most and the one we can reach fastest.
Wiring Cameras Into Mesa's Mix of Older and Newer Homes
As the first East Valley city to develop and the one that ended up biggest, Mesa carries an older mix of homes, and that age is the first thing we factor into a camera system install. A 1950s or 1960s ranch home near downtown Mesa is usually built with block walls, which means camera cable cannot simply be dropped down an open stud bay. We fish it through existing wall cavities, attics, and sometimes exterior conduit to reach the corners and entry points that matter most. Most of these older homes were never prewired for anything like a camera system, so retrofit work is the norm here, not the exception. Head further out toward Signal Butte, though, and the housing shifts to newer two-story construction with wood framing under stucco, which gives us easier paths for routing cable inside the walls, even though those properties tend to sit on larger parcels. A camera layout that covers a compact downtown yard will not cover a half-acre property with a long driveway, a side gate, and a detached garage. Security camera installation in Mesa has to account for both ends of that spread: older masonry construction that dictates how cable gets run, and larger east-side lots that dictate how many cameras and what angles are needed to actually see the whole property instead of just the front door.
What Actually Goes Into a Mesa Camera System
Security camera installation in Mesa usually comes down to choosing between two kinds of equipment. We install true CCTV systems built around Hikvision, LTS, Luma, or Illumivue, recording locally to a DVR or NVR that stays on the property, not in someone else’s cloud. Network, or IP, cameras connect over ethernet and can be powered directly through the recorder’s PoE ports, which suits newer Mesa construction where cable can be routed through open wall cavities and attic space fairly easily. Analog cameras run on coaxial cable with a separate power wire, and they’re often the practical choice for retrofitting an older block-wall home, especially one with existing coax paths already in place. We match the recorder’s drive capacity to the camera count on that job, and our general guideline is about 1TB of storage for each four motion-triggered cameras, which typically holds one to two weeks of footage before the system starts overwriting the oldest clips. There’s no subscription required to access your own footage once the system is installed.
Security Cameras in Mesa
Get Started
Mesa Questions
Yes, this is most of our retrofit work in Mesa. Because these block-wall houses were never prewired for security equipment, our crews route cable through whatever wall cavities and attic space already exist, and when it fits the job, we'll put analog cameras on coaxial runs rather than cut into finished drywall for a new cable path.
It depends on the layout, but larger east-side lots typically need more cameras than a standard suburban yard to cover a long driveway, side yards, and any detached structures. We walk the property and place cameras based on your actual sightlines rather than a fixed number.
Yes, but distance matters. Network cameras use ethernet cable, which has a 100 meter distance limit back to a switch or NVR. On a large East Mesa lot, we plan the cable path and, when a detached structure sits beyond that range, add a network switch partway along the run so cameras out by the shop or RV gate still record to the same system as the ones on the house.
It does. On a single-story ranch home near downtown, cameras mount at one consistent eave height that covers the whole yard. On a two-story build, we place upper cameras higher to see over block walls and cover more of the lot from the second story, and usually add a ground-floor camera at the entry for a straight-on view of anyone at the door.
We mount cameras and conduit in locations and colors that keep them low profile against stucco or block, which helps in most Mesa HOA neighborhoods. HOA architectural rules vary by community and we do not have them on file, so before installation we recommend checking your specific HOA's guidelines on exterior equipment, then we will place the cameras to fit within whatever they require.
Other Services We Provide in Mesa
Seamless entertainment throughout the home for the most enjoyable viewing and listening experience.
Cinemas of every caliber, designed to be enjoyed for years to come.
Quality sound is essential to fully enjoy your outdoor living space.
Your life, made easier. An authorized Control4 dealer serving the East Valley.
High-fidelity multi-room audio and the most advanced distributed video available for any home.
This page covers security camera installation in Mesa. For the full picture of how we approach this work across the Phoenix metro, see our main security cameras page. We also cover security cameras in Gilbert, security cameras in Tempe.